A gray electrical disconnect box on a tiled commercial kitchen wall beside a stainless convection oven, the oven's heavy power cord running up to it, the disconnect handle set to off, nobody near it.

Huebsch lit decimal point: the network link is down

On networked Huebsch Galaxy tumblers, the right-most decimal point lights when network communication has a problem.

(844) 571-4566

Mon–Sat, 8am–8pm

  • Controls and power
  • Commercial controls and board repair
  • Source: Huebsch

Book a visit

Three short steps, about a minute.

or call (844) 571-4566

What Right-most decimal point lit
actually means.

On networked Huebsch Galaxy tumblers, the right-most decimal point lights when network communication has a problem. Huebsch says to wait a minute and a half for it to clear, then power cycle, check the network connections and, if needed, replace the control or network board.

Huebsch commercial appliance display · also shown as network decimal point

What to do when Right-most decimal point lit shows on the commercial appliance

Before you book,
in this order.

Each step comes from Huebsch's own guidance for Right-most decimal point lit on its commercial appliances. Follow it to the end: the last card says whether this is a visit.

01

Wait at least 1.5 minutes for the dot to clear on its own.

02

Power cycle the pocket and check that other machines are online.

03

Book a visit if the dot stays lit, so cabling and the network board can be checked.

Still there?

It usually turns into commercial controls and board repair. Book with the code and the model number.

What not to do

The lit dot does not stop drying by itself; the pocket may still run from coins. It is not a heat or airflow message.

What you may
notice with it.

The commercial appliance problem Right-most decimal point lit tends to arrive with. Answer these at the commercial appliance before anyone is booked.

All problems

Where Right-most decimal point lit usually leads

Commercial controls and board repair.

Controller, touch panel, probe or sensor, relay, contactor, power supply, door switch or interlock, tested before anything is changed · moderate.

In Huebsch's own words

Wait for 1.5 minutes for error to clear.
Huebsch Galaxy 600 tumbler control manual 70474201ENR6 (Alliance Laundry Systems, 2023) Huebsch home page

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Huebsch vended tumblers with the Galaxy 600 control covered by manual 70474201ENR6: single 25 and 30 lb and stacked 30 lb pockets in gas, steam and electric versions.

Huebsch Right-most decimal point lit commercial appliance repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A restaurant team working a busy commercial kitchen line.
For the heart of your home.

Questions
about Right-most decimal point lit.

Can I clear Right-most decimal point lit myself?
Wait at least 1.5 minutes for the dot to clear on its own. If it comes back, it needs a visit.
What does the small dot on a Huebsch tumbler display mean?
The right-most decimal point shows a network communication problem between the pocket and the store system.
Will Huebsch Command still see a tumbler with the dot lit?
Not reliably, since the dot means the network link is down. Remote data will lag until it clears.
How long should I wait for the dot to clear on a Huebsch?
Huebsch says about 1.5 minutes before trying a power cycle.

Back to your everyday

Still showing Right-most decimal point lit?

A booking with a code goes further when it has the code as shown, the model and serial from the data plate, and a word on whether the unit still holds temperature, heats, rinses or spins. With those three, the office can match the likely part to your unit the same day.

(844) 571-4566 Schedule a repair