Delfield uLi: line voltage is below 96 volts
Delfield's controls report low line voltage when it falls below 96 volts.
Mon–Sat, 8am–8pm
- Controls and power
- Commercial controls and board repair
- Source: Delfield
Book a visit
Three short steps, about a minute.
or call (844) 571-4566
Loading appointment form…
The appointment form couldn’t load. Please try again.
What uLi
actually means.
Delfield's controls report low line voltage when it falls below 96 volts. A compressor started on low voltage draws more current and runs hot. The cause is almost always in the building supply or in how the unit is plugged in.
Delfield commercial appliance display · also shown as uLo
What to do when uLi shows on the commercial applianceKind of codeControls and power
The controller itself is reporting trouble, or the supply behind it is: a display with dead segments, a keypad that stopped responding after steam or degreaser got behind it, relays that stick, stored recipes or cycles that vanished overnight, a blown control fuse, or one leg of a three-phase feed missing so half the heat or the pump is gone. A full power cycle at the breaker, done as the manual describes, clears a passing glitch; a code that returns, a scorched smell or any sign of moisture behind the panel means the breaker stays off, and that is a visit.
Usually leads toCommercial controls and board repair
Controllers, touch panels, relays, contactors and interlocks tested, and replaced only when the evidence says so.
Shows up asCommercial Appliance Error Code on a Combi, Fryer, Dish Machine or Laundry Display
A commercial appliance error code appears as letters or numbers on a combi, fryer, reach-in controller, dish machine or laundry machine display, or as a flashing light or an alarm tone.
MakeDelfield
For a Delfield station that runs warm by late lunch, we time the visit to a slow hour so the pans can come out and the rail can be tested empty.
SourceDelfield 6000XL and 6100XL Series reach-ins, installation, operation and maintenance manual, part 9294254 (archived copy of the delfield.com PDF)
uLi in the 6000XL/6100XL reach-in manual and uLo in the 4400/4500 prep table manual, both below 96 volts.
Before you book,
in this order.
Each step comes from Delfield's own guidance for uLi on its commercial appliances. Follow it to the end: the last card says whether this is a visit.
Make sure the unit is on its own dedicated outlet, with no extension cord.
Note whether other equipment on the circuit starts at the same time the message appears.
Have an electrician measure the circuit, then book a visit if the unit still shows uLi on good voltage.
Still there?
It usually turns into commercial controls and board repair. Book with the code and the model number.
What not to do
uLi is not a failed control. It has a high-voltage twin, uHi, set at 140 volts.
What you may
notice with it.
The commercial appliance problem uLi tends to arrive with. Answer these at the commercial appliance before anyone is booked.
All problems
Where uLi usually leads
Commercial controls and board repair.
Delfield
commercial appliances.
For a Delfield station that runs warm by late lunch, we time the visit to a slow hour so the pans can come out and the rail can be tested empty.
Delfield commercial appliance repairMore Delfield codes
Controls and power on other makes
Commercial cold storage
Reach-in and pass-through cabinets, walk-in coolers and walk-in freezers, prep and sandwich tables, undercounter units and blast chillers that hold a kitchen's food at safe temperatures.
Commercial cooking equipment
Fryers, griddles, charbroilers, restaurant ranges, convection and combi ovens, steamers, kettles, holding cabinets and toasters, on gas or electric, that make up the hot side of a kitchen line.
In Delfield's own words
Line voltage too low, below 96 volts uLi
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. uLi in the 6000XL/6100XL reach-in manual and uLo in the 4400/4500 prep table manual, both below 96 volts.
Delfield uLi commercial appliance repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about uLi.
Can I clear uLi myself?
Why does my Delfield show uLi when the fryers heat up?
Is uLi the same as uLo on a Delfield?
Can I use an extension cord for my Delfield?
Back to your everyday
Still showing uLi?
A booking with a code goes further when it has the code as shown, the model and serial from the data plate, and a word on whether the unit still holds temperature, heats, rinses or spins. With those three, the office can match the likely part to your unit the same day.