Beverage-Air Con: the condenser is too hot or too cold
The condenser sheds the heat taken out of the cabinet.
Mon–Sat, 8am–8pm
- Compressor and cooling
- Walk-in cooler repair
- Source: Beverage-Air
Book a visit
Three short steps, about a minute.
or call (844) 571-4566
Loading appointment form…
The appointment form couldn’t load. Please try again.
What Con
actually means.
The condenser sheds the heat taken out of the cabinet. On the Cross Temp control, Con blinks when its temperature is outside the allowed band. A dusty coil or blocked grille is the usual cause of a hot condenser; a very cold room can push it the other way.
Beverage-Air commercial appliance display
What to do when Con shows on the commercial applianceKind of codeCompressor and cooling
The unit is running but not moving heat out of the box the way it should. On a walk-in that is often a condensing unit on the roof choking on cottonwood or grease, a condenser fan that stopped, an evaporator fan or defrost heater that failed so the coil iced solid, or a slow refrigerant leak; a reach-in adds a door gasket or heater that lets warm air in. Cleaning the condenser face with the power off and checking that the doors close are fair first steps; the refrigerant circuit, the compressor and every line stay with a technician.
Usually leads toWalk-in cooler repair
Walk-in coolers and freezers back to temperature: evaporators, fans, defrost, drain heaters, condensing units and doors.
Shows up asCommercial Appliance Error Code on a Combi, Fryer, Dish Machine or Laundry Display
A commercial appliance error code appears as letters or numbers on a combi, fryer, reach-in controller, dish machine or laundry machine display, or as a flashing light or an alarm tone.
MakeBeverage-Air
When a Beverage-Air cabinet drifts warm mid-shift, the first minutes of the visit go to where the food went and what the temperature log recorded.
SourceBeverage-Air Cross Temp (CT) freezer/refrigerator user manual, 809-154A (rev. 02/26)
Listed in the electronic controller alarms table of Beverage-Air's Cross Temp (CT) manual (rev. 02/26).
Before you book,
in this order.
Each step comes from Beverage-Air's own guidance for Con on its commercial appliances. Follow it to the end: the last card says whether this is a visit.
Unplug the unit and remove the front panel as the Cross Temp manual shows.
Brush the coil up and down with the fins and vacuum away the dust, without disturbing the controller wires.
Do not add an air filter; Beverage-Air says filters restrict cooling air.
If Con returns after cleaning or the coil is greasy, book a visit.
What not to do
Con is not a compressor failure. It is also not LEA, although a hot condenser can lead to LEA if left alone.
What you may
notice with it.
The commercial appliance problems Con tends to arrive with. Answer these at the commercial appliance before anyone is booked.
All problems
Where Con usually leads
Walk-in cooler repair.
Beverage-Air
commercial appliances.
When a Beverage-Air cabinet drifts warm mid-shift, the first minutes of the visit go to where the food went and what the temperature log recorded.
Beverage-Air commercial appliance repair
In Beverage-Air's own words
"Con" Condenser temperature is too
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Listed in the electronic controller alarms table of Beverage-Air's Cross Temp (CT) manual (rev. 02/26).
Beverage-Air Con commercial appliance repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about Con.
Can I clear Con myself?
How do I clean the condenser on a Beverage-Air Cross Temp?
Should I put a filter on my Beverage-Air condenser?
Why does my Beverage-Air show Con in winter?
Back to your everyday
Still showing Con?
A booking with a code goes further when it has the code as shown, the model and serial from the data plate, and a word on whether the unit still holds temperature, heats, rinses or spins. With those three, the office can match the likely part to your unit the same day.