A stainless sandwich prep table on a restaurant line, the prep table's lid raised over a row of covered food pans, a probe thermometer standing in one pan, nobody at the table.

Beverage-Air dOr: a door is open

The door switch tells the Beverage-Air control a door is open, and after the allowed time the display shows dOr (spelled dor in the Cross Temp alarm table).

(844) 571-4566

Mon–Sat, 8am–8pm

  • Temperature and alarms
  • Reach-in and prep table repair
  • Source: Beverage-Air

Book a visit

Three short steps, about a minute.

or call (844) 571-4566

What dOr
actually means.

The door switch tells the Beverage-Air control a door is open, and after the allowed time the display shows dOr (spelled dor in the Cross Temp alarm table). It clears as soon as the door is closed. A message that stays with the door shut points to the switch, its magnet or the door's alignment.

Beverage-Air commercial appliance display · also shown as dor

What to do when dOr shows on the commercial appliance

Before you book,
in this order.

Each step comes from Beverage-Air's own guidance for dOr on its commercial appliances. Follow it to the end: the last card says whether this is a visit.

01

Close the door and watch the display.

02

Check the hinge side for a sagging door and the gasket for folds.

03

If dOr stays with the door shut, book a visit.

Still there?

It usually turns into reach-in and prep table repair. Book with the code and the model number.

What not to do

dOr is not a warm alarm, but a door left open long enough causes one. The Cross Temp manual lists the door alarm as always active; it cannot be switched off by the user.

Where dOr usually leads

Reach-in and prep table repair.

Reach-in, pass-through or prep table gasket, hinge, fan motor, thermostat or controller, defrost heater, leak repair or compressor · moderate.

In Beverage-Air's own words

dOr Door is open Close door, if message does not
Beverage-Air Horizon Series HR reach-in user manual, 809-144A Beverage-Air Cross Temp (CT) freezer/refrigerator user manual, 809-154A (rev. 02/26)

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Listed in the 'message displayed' table of Beverage-Air's Horizon HR reach-in, SPE prep table and Cross Temp manuals (2026 editions).

Beverage-Air dOr commercial appliance repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A restaurant team working a busy commercial kitchen line.
For the heart of your home.

Questions
about dOr.

Can I clear dOr myself?
Close the door and watch the display. If it comes back, it needs a visit.
Why does my Beverage-Air show dOr with the door closed?
The switch still reads open. The door may have dropped on its hinges or the switch may be worn.
Can I turn off the door alarm on my Beverage-Air?
The Cross Temp manual lists it as always active. If it trips during normal loading, ask about the delay setting.
Does a Beverage-Air glass door model use the same dOr message?
The message tables in the Horizon and prep table manuals list the same dOr line; the glass door light is a separate button.

Back to your everyday

Still showing dOr?

A booking with a code goes further when it has the code as shown, the model and serial from the data plate, and a word on whether the unit still holds temperature, heats, rinses or spins. With those three, the office can match the likely part to your unit the same day.

(844) 571-4566 Schedule a repair