A commercial condensing unit mounted on top of a walk-in cooler in a restaurant back room, its condenser fan guard and dusty coil face in view, insulated copper lines running down into the walk-in cooler's roof panel, nobody near the unit.

Randell LEA: the compressor has been running without a break

Randell describes LEA as continuous compressor runtime.

(844) 571-4566

Mon–Sat, 8am–8pm

  • Compressor and cooling
  • Walk-in cooler repair
  • Source: Randell

Book a visit

Three short steps, about a minute.

or call (844) 571-4566

What LEA
actually means.

Randell describes LEA as continuous compressor runtime. The compressor has been running without cycling off for longer than the control accepts, usually because warm air keeps getting in or the condenser cannot shed heat. Randell's actions are to inspect door and drawer sealing, clean the condenser if needed, then contact service.

Randell commercial appliance display

What to do when LEA shows on the commercial appliance

Before you book,
in this order.

Each step comes from Randell's own guidance for LEA on its commercial appliances. Follow it to the end: the last card says whether this is a visit.

01

Check that doors, drawers and rail covers close and seal fully.

02

Clean the condenser coil if it is dusty, with the power off.

03

Probe food and log it while the cause is found.

04

If LEA returns after those checks, book a visit.

Still there?

It usually turns into walk-in cooler repair. Book with the code and the model number.

What not to do

LEA on a Randell is a run-time warning, not a leak test result. A refrigerant problem is one possible cause, but only a technician can confirm it.

Where LEA usually leads

Walk-in cooler repair.

Walk-in evaporator fan, defrost heater or drain line heater, door gasket, frame heater, expansion valve, leak repair, compressor or condensing unit · moderate to highest.

In Randell's own words

Continuous Compressor Runtime
Randell 9200-290 sidemount series operator manual, PP MNL2501 rev. B (12/25) Randell 9200-290 sidemount series operator manual, PP MNL2501 rev. B (12/25)

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Listed in the Danfoss controller codes table of Randell's 9200-290 sidemount operator manual (rev. B, 12/25).

Randell LEA commercial appliance repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A restaurant team working a busy commercial kitchen line.
For the heart of your home.

Questions
about LEA.

Can I clear LEA myself?
Check that doors, drawers and rail covers close and seal fully. If it comes back, it needs a visit.
What makes a Randell compressor run nonstop?
Gaps in door or drawer seals, open rail covers and a dirty condenser top the list. Each keeps the cabinet from reaching set point.
Does LEA on a Randell mean it is out of refrigerant?
Not necessarily. Randell's own first steps are the seals and the condenser.
Will LEA on a Randell clear itself?
Once the compressor manages to cycle off, the alarm has no reason to stay. If it keeps coming back, book a visit.

Back to your everyday

Still showing LEA?

A booking with a code goes further when it has the code as shown, the model and serial from the data plate, and a word on whether the unit still holds temperature, heats, rinses or spins. With those three, the office can match the likely part to your unit the same day.

(844) 571-4566 Schedule a repair