CommercialApplianceRepair.center (844) 571-4566Mon–Sat, 8am–8pm Book a visit
A stainless sandwich prep table on a restaurant line, the prep table's lid raised over a row of covered food pans, a probe thermometer standing in one pan, nobody at the table.

Turbo Air ED: a door has been open for an hour

The board records ED when the door switch reads open for an hour.

(844) 571-4566

Mon–Sat, 8am–8pm

  • Temperature and alarms
  • Reach-in and prep table repair
  • Source: Turbo Air

Book a visit

Three short steps, about a minute.

or call (844) 571-4566

What ED
actually means.

The board records ED when the door switch reads open for an hour. On a busy line that usually means a door propped during a delivery or a door that does not close fully. An hour of open door is long enough to warm the cabinet.

Turbo Air commercial appliance display · also shown as Ed

What to do when ED shows on the commercial appliance

Kind of codeTemperature and alarms

The controller has seen a temperature outside the band it was set for and is saying so: a box above its alarm point, a fryer vat or an oven cavity that tripped its high-limit, or a dish machine rinse that never came up to heat. Often the cause sits outside the unit, such as a door left open during a delivery, a coil packed with grease, a kitchen far hotter than the maker allows or a booster fed cold water. Checking the door, the coil and the air around the unit is fair; move the product if a cold box stays above 41°F, and book the visit.

Usually leads toReach-in and prep table repair

Reach-ins, pass-throughs, prep tables and blast chillers: gaskets, hinges, fans, thermostats, condensers and compressors.

Shows up asCommercial Appliance Error Code on a Combi, Fryer, Dish Machine or Laundry Display

A commercial appliance error code appears as letters or numbers on a combi, fryer, reach-in controller, dish machine or laundry machine display, or as a flashing light or an alarm tone.

MakeTurbo Air

Turbo Air cabinets in a busy kitchen tend to get a visit between shifts, with the manager present to sign off the log.

SourceTurbo Air PCB settings service sheet (control menu and error codes), turboairinc.com resource center

Read from the error code item (ER) of the control menu, opened by holding both temperature buttons until SL shows, as laid out on Turbo Air's PCB settings sheet.

Before you book,
in this order.

Each step comes from Turbo Air's own guidance for ED on its commercial appliances. Follow it to the end: the last card says whether this is a visit.

01

Close the door firmly and check nothing is holding it open.

02

Probe the food and log it, since an hour of open door warms the cabinet.

03

If the door closes but ED is recorded again, book a visit to test the door switch.

Still there?

It usually turns into reach-in and prep table repair. Book with the code and the model number.

What not to do

ED is not a temperature alarm, but warm food can follow. Some Turbo Air models are set to run without a door switch, so the technician checks the door-switch setting too.

What you may
notice with it.

The commercial appliance problems ED tends to arrive with. Answer these at the commercial appliance before anyone is booked.

All problems

Before you call

Commercial Appliance Error Code on a Combi, Fryer, Dish Machine or Laundry Display

All 8 causes, cheapest first

It also comes with

Close view of the dark touch control panel on the front of a stainless combi oven in a commercial kitchen, one abstract amber warning indicator glowing among unlit icons, the steam-fogged glass door blurred beside it. Problem

Commercial Appliance Error Code on a Combi, Fryer, Dish Machine or Laundry Display

8 causes, cheapest first

Where ED usually leads

Reach-in and prep table repair.

Reach-in, pass-through or prep table gasket, hinge, fan motor, thermostat or controller, defrost heater, leak repair or compressor · moderate.
Book a visit What the job involves

Turbo Air
commercial appliances.

Turbo Air cabinets in a busy kitchen tend to get a visit between shifts, with the manager present to sign off the log.

Turbo Air commercial appliance repair

More Turbo Air codes

F0F1r0r1d0d1C1F3S1

Temperature and alarms on other makes

Alto-Shaam E13Beverage-Air HiBlodgett Cavity High Temp ErrorCleveland RESET lightContinental Refrigerator HIDelfield HiFrymaster E16Garland E04
All 72 codes of this kind
A row of three stainless steel reach-in cabinets with solid doors along the wall of a working restaurant kitchen, the reach-ins clearly the subject, one door open showing sheet pans of prepped vegetables on wire shelves, a walk-in cooler door with a clear strip curtain visible at the far end, a cook seen only from behind in a white jacket passing in the soft background, bright even kitchen light. Turbo Air builds this

Commercial cold storage

Reach-in and pass-through cabinets, walk-in coolers and walk-in freezers, prep and sandwich tables, undercounter units and blast chillers that hold a kitchen's food at safe temperatures.

 A working restaurant cooking line under a stainless ventilation hood, two stainless gas fryers with baskets hanging above the oil, a flat griddle and a combi oven with a glass door beside them, the equipment clearly the subject, a cook seen only from behind and shoulders down at the far end of the line, warm kitchen light, small blue flames visible under the griddle. Turbo Air builds this

Commercial cooking equipment

Fryers, griddles, charbroilers, restaurant ranges, convection and combi ovens, steamers, kettles, holding cabinets and toasters, on gas or electric, that make up the hot side of a kitchen line.

In Turbo Air's own words

Door open for 1 hour
Turbo Air PCB settings service sheet (control menu and error codes), turboairinc.com resource center

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Read from the error code item (ER) of the control menu, opened by holding both temperature buttons until SL shows, as laid out on Turbo Air's PCB settings sheet.

Turbo Air ED commercial appliance repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas

Tampa BayFL · 31 areas

OrlandoFL · 30 areas

Miami / South FloridaFL · 47 areas

New York MetroNY · 75 areas

HoustonTX · 36 areas

ChicagoIL · 50 areas

Los AngelesCA · 95 areas

San DiegoCA · 31 areas

San Francisco Bay AreaCA · 74 areas

A restaurant team working a busy commercial kitchen line.
For the heart of your home.

Questions
about ED.

Can I clear ED myself?
Close the door firmly and check nothing is holding it open. If it comes back, it needs a visit.
Why does my Turbo Air record ED?
The door switch saw the door open for an hour. Check for a propped door or a gasket that does not seal.
Can a Turbo Air door switch be set wrong?
Turbo Air's settings sheets include a door switch type setting. A wrong setting or a worn switch can both cause false door readings.
Does ED mean my Turbo Air food is unsafe?
Not by itself. Probe the food and follow your health code if it has been above 41°F.

Back to your everyday

Still showing ED?

A booking with a code goes further when it has the code as shown, the model and serial from the data plate, and a word on whether the unit still holds temperature, heats, rinses or spins. With those three, the office can match the likely part to your unit the same day.

Schedule a repair Call (844) 571-4566
(844) 571-4566 Schedule a repair