A stainless sandwich prep table on a restaurant line, the prep table's lid raised over a row of covered food pans, a probe thermometer standing in one pan, nobody at the table.

Blodgett HIGH-LIMIT-ERROR: the Xcel combi locked its door during cleaning

Blodgett's service note describes an Xcel combi that beeps, locks its door and shows WARNING and HIGH-LIMIT-ERROR during cleaning.

(844) 571-4566

Mon–Sat, 8am–8pm

  • Temperature and alarms
  • Reach-in and prep table repair
  • Source: Blodgett

Book a visit

Three short steps, about a minute.

or call (844) 571-4566

What HIGH-LIMIT-ERROR
actually means.

Blodgett's service note describes an Xcel combi that beeps, locks its door and shows WARNING and HIGH-LIMIT-ERROR during cleaning. A short menu sequence tells you which case you have: Product Cnt means the lockout has cleared, while Service Code means hot water and cleaning chemical are trapped inside and the door must not be opened by staff.

Blodgett commercial appliance display · also shown as HIGH-LIMIT-ERROR, WARNING HIGH-LIMIT-ERROR

What to do when HIGH-LIMIT-ERROR shows on the commercial appliance

Before you book,
in this order.

Each step comes from Blodgett's own guidance for HIGH-LIMIT-ERROR on its commercial appliances. Follow it to the end: the last card says whether this is a visit.

01

Do not force the door; hot water and cleaner can be trapped inside.

02

Follow the unlock steps in Blodgett's note: power on, hold Clean for 5 seconds, then hold P until the display changes.

03

If the display shows Product Cnt, power off, unplug for a minute, then open the door slowly and clear the drain or vent before rerunning the clean; if it shows Service Code, leave it closed and arrange service.

Still there?

It usually turns into reach-in and prep table repair. Book with the code and the model number.

What not to do

HIGH-LIMIT-ERROR here is tied to the cleaning cycle and a blocked drain or vent, not to normal cooking. The High Temp Error of the BC-series controls is a different message.

What you may
notice with it.

The commercial appliance problems HIGH-LIMIT-ERROR tends to arrive with. Answer these at the commercial appliance before anyone is booked.

All problems

Where HIGH-LIMIT-ERROR usually leads

Reach-in and prep table repair.

Reach-in, pass-through or prep table gasket, hinge, fan motor, thermostat or controller, defrost heater, leak repair or compressor · moderate.

In Blodgett's own words

Oven beeps, door is locked and “WARNING”“HIGH-LIMIT-ERROR” appears in the display!
Blodgett Xcel combi oven high-limit lockout service note Blodgett Xcel combi oven high-limit lockout service note Blodgett Xcel combi oven high-limit lockout service note

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Blodgett Xcel combi ovens (service note on the high-limit lockout during cleaning).

Blodgett HIGH-LIMIT-ERROR commercial appliance repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A restaurant team working a busy commercial kitchen line.
For the heart of your home.

Questions
about HIGH-LIMIT-ERROR.

Can I clear HIGH-LIMIT-ERROR myself?
Do not force the door; hot water and cleaner can be trapped inside. If it comes back, it needs a visit.
Why won't my Blodgett Xcel door open after cleaning?
The oven locked itself after a high limit event during the clean. Follow the unlock steps and do not force the door.
What does Service Code mean on a Blodgett Xcel lockout?
Water and cleaning chemical are trapped inside, so a technician should open it.
How do I stop the Blodgett Xcel lockout from repeating?
Clear the drain, vent and drain hose before cleaning again, as Blodgett's note advises.

Back to your everyday

Still showing HIGH-LIMIT-ERROR?

A booking with a code goes further when it has the code as shown, the model and serial from the data plate, and a word on whether the unit still holds temperature, heats, rinses or spins. With those three, the office can match the likely part to your unit the same day.

(844) 571-4566 Schedule a repair