A stainless door-type dish machine in a restaurant dish room with its hood raised and its wash chamber empty, a clean wire rack on the landing table beside it, the tiled floor dry, nobody at the dish machine.

Speed Queen E dr: water is still in the tub after the drain time

E dr appears when the drain error check is switched on and the tub has not emptied after the drain step's time limit.

(844) 571-4566

Mon–Sat, 8am–8pm

  • Water, fill and drain
  • Dish machine repair
  • Source: Speed Queen

Book a visit

Three short steps, about a minute.

or call (844) 571-4566

What E dr
actually means.

E dr appears when the drain error check is switched on and the tub has not emptied after the drain step's time limit. The control then stops every output and sounds its error tone for 15 seconds, leaving a load of wet laundry inside.

Speed Queen commercial appliance display · also shown as EdR, E DR

What to do when E dr shows on the commercial appliance

Before you book,
in this order.

Each step comes from Speed Queen's own guidance for E dr on its commercial appliances. Follow it to the end: the last card says whether this is a visit.

01

Do not force the door; wait for the control to unlock it.

02

Look at the floor drain or trough the machine empties into and clear anything backing it up.

03

Take the machine out of service and book a visit if the tub still holds water, since the drain valve or pump sits behind the panels.

Still there?

It usually turns into dish machine repair. Book with the code and the model number.

What not to do

E dr is not an overflow: E oF is the code for water rising to an unsafe height. A load that drains but stays soaked after spin is a separate spin speed issue.

Where E dr usually leads

Dish machine repair.

Dish machine tank heater or booster element, thermostat, fill valve, float switch, drain valve, wash pump seal or motor, conveyor drive · moderate.

In Speed Queen's own words

when the water height is not below the empty level, after attempting to drain for the programmable time (default 15 minutes).
Speed Queen commercial front-load vended models, control manual 807870ENR5 (Alliance Laundry Systems)

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Speed Queen commercial front-load vended and card models listed in manual 807870ENR5, such as SFNNCASP116TW01 and STGNXASP116TW01.

Speed Queen E dr commercial appliance repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A restaurant team working a busy commercial kitchen line.
For the heart of your home.

Questions
about E dr.

Can I clear E dr myself?
Do not force the door; wait for the control to unlock it. If it comes back, it needs a visit.
What clears E dr on a Speed Queen commercial front-load?
The drain has to work first. Once the tub is empty, cycling power clears the display, but the code will come back on the next load if the drain path is still slow.
Why does E dr show up on several Speed Queen machines at once?
A shared drain trough or floor drain that backs up will slow every machine emptying into it. Clear the building drain before anyone opens a cabinet.
Can a sock stop a Speed Queen from draining?
Small items can reach the drain path on front-loads and slow it down. Removing them means opening the machine, which is a job for the visit.

Back to your everyday

Still showing E dr?

A booking with a code goes further when it has the code as shown, the model and serial from the data plate, and a word on whether the unit still holds temperature, heats, rinses or spins. With those three, the office can match the likely part to your unit the same day.

(844) 571-4566 Schedule a repair