Speed Queen E FL: the laundry machine did not fill in time
On Speed Queen vended front-loads, E FL is logged when a fill step runs out of time before the water reaches the level the cycle asks for.
Mon–Sat, 8am–8pm
- Water, fill and drain
- Dish machine repair
- Source: Speed Queen
Book a visit
Three short steps, about a minute.
or call (844) 571-4566
Loading appointment form…
The appointment form couldn’t load. Please try again.
What E FL
actually means.
On Speed Queen vended front-loads, E FL is logged when a fill step runs out of time before the water reaches the level the cycle asks for. The usual causes sit outside the cabinet: a closed or half-open supply valve, low building pressure or clogged inlet screens.
Speed Queen commercial appliance display · also shown as EFL
What to do when E FL shows on the commercial applianceKind of codeWater, fill and drain
Water is not arriving, not reaching its level, not heating or not leaving on time. A dish machine may be short of fill because a supply valve is half closed or its line strainer is clogged, it may drain slowly through a scrap basket full of debris, or its booster may be too scaled to heat the rinse; a combi's steam generator may be scaled or its water treatment exhausted; a washer-extractor may time out on a slow drain. Opening the supply valve, cleaning strainers with the unit off and checking the drain line are fair; a pump, a fill valve, a heater or a leak near wiring is a visit.
Usually leads toDish machine repair
Undercounter, door-type and conveyor dish machines: tank heaters, boosters, wash pumps, fill and drain valves.
Shows up asCommercial Appliance Error Code on a Combi, Fryer, Dish Machine or Laundry Display
A commercial appliance error code appears as letters or numbers on a combi, fryer, reach-in controller, dish machine or laundry machine display, or as a flashing light or an alarm tone.
MakeSpeed Queen
A Speed Queen machine in a laundromat or apartment laundry room is often booked for a weekday morning, when the fewest customers are waiting.
SourceSpeed Queen commercial front-load vended models, control manual 807870ENR5 (Alliance Laundry Systems)
Speed Queen commercial front-load vended and card models listed in manual 807870ENR5, such as SFNNCASP116TW01 and STGNXASP116TW01.
Before you book,
in this order.
Each step comes from Speed Queen's own guidance for E FL on its commercial appliances. Follow it to the end: the last card says whether this is a visit.
Check that the hot and cold supply valves behind the machine are fully open.
Ask whether other machines on the same line are filling slowly; a building-wide pressure drop points away from this unit.
Power the machine off and on, run a short cycle and watch the fill; if E FL returns, take it out of service and book a visit.
What not to do
E FL is a timing message, not a leak alarm: water on the floor points to a hose or door seal instead. It is also different from E nFLo, where the level sensor sees almost no water at all.
What you may
notice with it.
The commercial appliance problem E FL tends to arrive with. Answer these at the commercial appliance before anyone is booked.
All problems
Where E FL usually leads
Dish machine repair.
Speed Queen
commercial appliances.
A Speed Queen machine in a laundromat or apartment laundry room is often booked for a weekday morning, when the fewest customers are waiting.
Speed Queen commercial appliance repairMore Speed Queen codes
All 14 Speed Queen codesWater, fill and drain on other makes
In Speed Queen's own words
Fill level is not reached within 30 minutes (or other programmed length of time) in any fill step.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Speed Queen commercial front-load vended and card models listed in manual 807870ENR5, such as SFNNCASP116TW01 and STGNXASP116TW01.
Speed Queen E FL commercial appliance repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about E FL.
Can I clear E FL myself?
Why does a Speed Queen vended front-load show E FL after a plumber visit?
Can a Speed Queen keep running with E FL showing?
Is E FL on one Speed Queen and not the others a sign of a bad valve?
Back to your everyday
Still showing E FL?
A booking with a code goes further when it has the code as shown, the model and serial from the data plate, and a word on whether the unit still holds temperature, heats, rinses or spins. With those three, the office can match the likely part to your unit the same day.