

Victory rSF: the refrigerant leak alarm has tripped
rSF, log code 31, is the refrigerant leak alarm.
Mon–Sat, 8am–8pm
- Compressor and cooling
- Walk-in cooler repair
- Source: Victory
Book a visit
Three short steps, about a minute.
or call (844) 571-4566
Loading appointment form…
The appointment form couldn’t load. Please try again.
What rSF
actually means.
rSF, log code 31, is the refrigerant leak alarm. Victory's table says it switches off all actuators, so the unit stops cooling. Victory's hydrocarbon units run on a flammable refrigerant, so this alarm deserves care.
Victory commercial appliance display
What to do when rSF shows on the commercial applianceKind of codeCompressor and cooling
The unit is running but not moving heat out of the box the way it should. On a walk-in that is often a condensing unit on the roof choking on cottonwood or grease, a condenser fan that stopped, an evaporator fan or defrost heater that failed so the coil iced solid, or a slow refrigerant leak; a reach-in adds a door gasket or heater that lets warm air in. Cleaning the condenser face with the power off and checking that the doors close are fair first steps; the refrigerant circuit, the compressor and every line stay with a technician.
Usually leads toWalk-in cooler repair
Walk-in coolers and freezers back to temperature: evaporators, fans, defrost, drain heaters, condensing units and doors.
Shows up asCommercial Appliance Error Code on a Combi, Fryer, Dish Machine or Laundry Display
A commercial appliance error code appears as letters or numbers on a combi, fryer, reach-in controller, dish machine or laundry machine display, or as a flashing light or an alarm tone.
MakeVictory
Victory cabinets in an institutional or hotel kitchen are visited with the kitchen manager on hand to confirm the temperature log.
SourceVictory RS and RSA reach-in installation and operating instructions, 809-190A rev. H (02/05/2026)
From the alarm code table of the Carel control in Victory's RS/RSA reach-in manual (809-190A rev. H, 2026); the HS/HIS warming cabinet manual carries the same table.
Before you book,
in this order.
Each step comes from Victory's own guidance for rSF on its commercial appliances. Follow it to the end: the last card says whether this is a visit.
Do not reset rSF repeatedly or open any panel.
If you smell gas or hear a hiss, keep flames and switches away, ventilate and move people out of the area.
Move food to a working unit and log temperatures.
Book a visit; a leak check is technician work.
What not to do
rSF is not the high condensing alarm, which is CHt. A reset may restart the unit, but the reason for the alarm stays until it is found.
What you may
notice with it.
The commercial appliance problems rSF tends to arrive with. Answer these at the commercial appliance before anyone is booked.
All problemsWhere rSF usually leads
Walk-in cooler repair.
Victory
commercial appliances.
Victory cabinets in an institutional or hotel kitchen are visited with the kitchen manager on hand to confirm the temperature log.
Victory commercial appliance repairMore Victory codes
All 14 Victory codesCompressor and cooling on other makes
All 14 codes of this kind
Commercial cold storage
Reach-in and pass-through cabinets, walk-in coolers and walk-in freezers, prep and sandwich tables, undercounter units and blast chillers that hold a kitchen's food at safe temperatures.
Commercial cooking equipment
Fryers, griddles, charbroilers, restaurant ranges, convection and combi ovens, steamers, kettles, holding cabinets and toasters, on gas or electric, that make up the hot side of a kitchen line.
In Victory's own words
rSF 31 Refrigerant leak alarm YES YES YES Manual Switch off all actuators
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. From the alarm code table of the Carel control in Victory's RS/RSA reach-in manual (809-190A rev. H, 2026); the HS/HIS warming cabinet manual carries the same table.
Victory rSF commercial appliance repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about rSF.
Can I clear rSF myself?
Is rSF on my Victory dangerous?
Can I reset rSF on a Victory myself?
Why did my Victory stop completely with rSF?
Back to your everyday
Still showing rSF?
A booking with a code goes further when it has the code as shown, the model and serial from the data plate, and a word on whether the unit still holds temperature, heats, rinses or spins. With those three, the office can match the likely part to your unit the same day.