A stainless sandwich prep table on a restaurant line, the prep table's lid raised over a row of covered food pans, a probe thermometer standing in one pan, nobody at the table.

Victory HF: a HACCP record of high temperature after a blackout

HF, log code 22, is the HACCP record the control keeps when the cabinet came back from a blackout above its limit.

(844) 571-4566

Mon–Sat, 8am–8pm

  • Temperature and alarms
  • Reach-in and prep table repair
  • Source: Victory

Book a visit

Three short steps, about a minute.

or call (844) 571-4566

What HF
actually means.

HF, log code 22, is the HACCP record the control keeps when the cabinet came back from a blackout above its limit. Like HA it shows without the buzzer and stays until reset, so the kitchen can see that food may have warmed while the power was off.

Victory commercial appliance display

What to do when HF shows on the commercial appliance

Before you book,
in this order.

Each step comes from Victory's own guidance for HF on its commercial appliances. Follow it to the end: the last card says whether this is a visit.

01

Find out how long the power was off and probe the food.

02

Decide on discard as your health code directs and note it on your log.

03

Reset HF once recorded.

04

If HF appears with no outage you know of, book a visit to check the supply to the unit.

Still there?

It usually turns into reach-in and prep table repair. Book with the code and the model number.

What not to do

HF does not mean the control failed. It is a food safety note tied to a power loss, different from HA, which covers warm spells during normal running.

Where HF usually leads

Reach-in and prep table repair.

Reach-in, pass-through or prep table gasket, hinge, fan motor, thermostat or controller, defrost heater, leak repair or compressor · moderate.

In Victory's own words

HF 22 Type HF HACCP alarm (high NO NO NO Manual
Victory RS and RSA reach-in installation and operating instructions, 809-190A rev. H (02/05/2026) Victory RS and RSA reach-in installation and operating instructions, 809-190A rev. H (02/05/2026)

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. From the alarm code table of the Carel control in Victory's RS/RSA reach-in manual (809-190A rev. H, 2026); the HS/HIS warming cabinet manual carries the same table.

Victory HF commercial appliance repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A restaurant team working a busy commercial kitchen line.
For the heart of your home.

Questions
about HF.

Can I clear HF myself?
Find out how long the power was off and probe the food. If it comes back, it needs a visit.
What should I do with food when my Victory shows HF?
Probe it and apply your health code's rules for time above 41°F. The HF record shows the cabinet warmed after the outage.
Why does my Victory show HF after a short outage?
Even a short outage can let the cabinet warm past its limit, especially if doors were opened during it.
Does HF on a Victory clear itself?
No. Victory lists it as a manual reset.

Back to your everyday

Still showing HF?

A booking with a code goes further when it has the code as shown, the model and serial from the data plate, and a word on whether the unit still holds temperature, heats, rinses or spins. With those three, the office can match the likely part to your unit the same day.

(844) 571-4566 Schedule a repair