A gray electrical disconnect box on a tiled commercial kitchen wall beside a stainless convection oven, the oven's heavy power cord running up to it, the disconnect handle set to off, nobody near it.

Victory SrC: the control is asking for maintenance

SrC, log code 35, is the Carel control's maintenance reminder.

(844) 571-4566

Mon–Sat, 8am–8pm

  • Controls and power
  • Commercial controls and board repair
  • Source: Victory

Book a visit

Three short steps, about a minute.

or call (844) 571-4566

What SrC
actually means.

SrC, log code 35, is the Carel control's maintenance reminder. It lights the icon, trips the relay and sounds the buzzer until someone resets it. It is the control's way of saying a service interval has come around.

Victory commercial appliance display

What to do when SrC shows on the commercial appliance

Before you book,
in this order.

Each step comes from Victory's own guidance for SrC on its commercial appliances. Follow it to the end: the last card says whether this is a visit.

01

Check that the cabinet is holding temperature.

02

Clean the condenser coil and gaskets as Victory's cleaning schedule describes.

03

Book a maintenance visit, and have the technician reset SrC afterward.

Still there?

It usually turns into commercial controls and board repair. Book with the code and the model number.

What not to do

SrC is not a failure report. It is a reminder, but the buzzer keeps sounding until it is reset.

What you may
notice with it.

The commercial appliance problem SrC tends to arrive with. Answer these at the commercial appliance before anyone is booked.

All problems

Where SrC usually leads

Commercial controls and board repair.

Controller, touch panel, probe or sensor, relay, contactor, power supply, door switch or interlock, tested before anything is changed · moderate.

In Victory's own words

SrC 35 Maintenance request YES YES YES Manual
Victory RS and RSA reach-in installation and operating instructions, 809-190A rev. H (02/05/2026)

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. From the alarm code table of the Carel control in Victory's RS/RSA reach-in manual (809-190A rev. H, 2026); the HS/HIS warming cabinet manual carries the same table.

Victory SrC commercial appliance repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A restaurant team working a busy commercial kitchen line.
For the heart of your home.

Questions
about SrC.

Can I clear SrC myself?
Check that the cabinet is holding temperature. If it comes back, it needs a visit.
Why is my Victory beeping with SrC?
The control is asking for a maintenance visit. The cabinet is usually working fine.
Can I reset SrC on a Victory myself?
It is a manual reset, but it is best cleared after the maintenance is done so the next reminder is set properly.
What does Victory maintenance include?
Victory's schedule covers daily wipe-downs, a weekly interior clean, a monthly condenser inspection and an annual routine check.

Back to your everyday

Still showing SrC?

A booking with a code goes further when it has the code as shown, the model and serial from the data plate, and a word on whether the unit still holds temperature, heats, rinses or spins. With those three, the office can match the likely part to your unit the same day.

(844) 571-4566 Schedule a repair