

Alto-Shaam E105: no or low water pressure at the oven
The CTP checks that its incoming water has enough pressure before it relies on it.
Mon–Sat, 8am–8pm
- Water, fill and drain
- Dish machine repair
- Source: Alto-Shaam
Book a visit
Three short steps, about a minute.
or call (844) 571-4566
Loading appointment form…
The appointment form couldn’t load. Please try again.
What E105
actually means.
The CTP checks that its incoming water has enough pressure before it relies on it. E105 is called out when the pressure switch does not activate. The manual lists a disconnected or closed supply, or a blocked line, with the water filter as the place to look.
Alto-Shaam commercial appliance display
What to do when E105 shows on the commercial applianceKind of codeWater, fill and drain
Water is not arriving, not reaching its level, not heating or not leaving on time. A dish machine may be short of fill because a supply valve is half closed or its line strainer is clogged, it may drain slowly through a scrap basket full of debris, or its booster may be too scaled to heat the rinse; a combi's steam generator may be scaled or its water treatment exhausted; a washer-extractor may time out on a slow drain. Opening the supply valve, cleaning strainers with the unit off and checking the drain line are fair; a pump, a fill valve, a heater or a leak near wiring is a visit.
Usually leads toDish machine repair
Undercounter, door-type and conveyor dish machines: tank heaters, boosters, wash pumps, fill and drain valves.
Shows up asCommercial Appliance Error Code on a Combi, Fryer, Dish Machine or Laundry Display
A commercial appliance error code appears as letters or numbers on a combi, fryer, reach-in controller, dish machine or laundry machine display, or as a flashing light or an alarm tone.
MakeAlto-Shaam
An Alto-Shaam call is usually booked for the hours between the last plate and the prep crew, so the cabinet can cool and the tech can open it without holding up service.
SourceAlto-Shaam Combitherm CT PROformance Series operator's manual, MN-35948 Rev 21 (10/21) (Wayback copy)
Combitherm CT PROformance (CTP) combi ovens, error code table in operator's manual MN-35948 Rev 21.
Before you book,
in this order.
Each step comes from Alto-Shaam's own guidance for E105 on its commercial appliances. Follow it to the end: the last card says whether this is a visit.
Check that the water supply is connected and its valve is open.
Look at the water filter ahead of the oven; a clogged cartridge can starve the line.
When supply and filter both look right and E105 remains, book a visit.
What not to do
E105 is not the steam generator failing to fill, which roll-in models report as E01 or E51. It is also different from E57, which watches the rinse water flow alone.
What you may
notice with it.
The commercial appliance problems E105 tends to arrive with. Answer these at the commercial appliance before anyone is booked.
All problemsWhere E105 usually leads
Dish machine repair.
Alto-Shaam
commercial appliances.
An Alto-Shaam call is usually booked for the hours between the last plate and the prep crew, so the cabinet can cool and the tech can open it without holding up service.
Alto-Shaam commercial appliance repairMore Alto-Shaam codes
All 15 Alto-Shaam codesWater, fill and drain on other makes
Commercial cold storage
Reach-in and pass-through cabinets, walk-in coolers and walk-in freezers, prep and sandwich tables, undercounter units and blast chillers that hold a kitchen's food at safe temperatures.
Commercial cooking equipment
Fryers, griddles, charbroilers, restaurant ranges, convection and combi ovens, steamers, kettles, holding cabinets and toasters, on gas or electric, that make up the hot side of a kitchen line.
In Alto-Shaam's own words
Water pressure switch not activated.
Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Combitherm CT PROformance (CTP) combi ovens, error code table in operator's manual MN-35948 Rev 21.
Alto-Shaam E105 commercial appliance repair,
where we come out.
The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.
All service areasTampa BayFL · 31 areas
Miami / South FloridaFL · 47 areas
New York MetroNY · 75 areas
HoustonTX · 36 areas
ChicagoIL · 50 areas
Los AngelesCA · 95 areas
San DiegoCA · 31 areas
Questions
about E105.
Can I clear E105 myself?
Why did my Alto-Shaam show E105 right after a filter change?
Does a clogged water filter cause E105 on an Alto-Shaam?
Can I bake on an Alto-Shaam with E105?
Back to your everyday
Still showing E105?
A booking with a code goes further when it has the code as shown, the model and serial from the data plate, and a word on whether the unit still holds temperature, heats, rinses or spins. With those three, the office can match the likely part to your unit the same day.