A stainless door-type dish machine in a restaurant dish room with its hood raised and its wash chamber empty, a clean wire rack on the landing table beside it, the tiled floor dry, nobody at the dish machine.

Pitco DRAINING TURN OFF: the drain is open while the fryer is on

Pitco fryers with a drain valve interlock stop heating the moment the tank drain valve opens, so an emptying tank is never fired.

(844) 571-4566

Mon–Sat, 8am–8pm

  • Water, fill and drain
  • Dish machine repair
  • Source: Pitco

Book a visit

Three short steps, about a minute.

or call (844) 571-4566

What DRAINING TURN OFF
actually means.

Pitco fryers with a drain valve interlock stop heating the moment the tank drain valve opens, so an emptying tank is never fired. The control scrolls the message and waits. If the blue drain handle is truly closed and the message stays, the drain switch is misadjusted or has failed, and on automatic filter models the drain valve may be blocked from closing.

Pitco commercial appliance display · also shown as Draining Turn Off, DRN TRN OFF, drn tUrn oFF, DRAINING

What to do when DRAINING TURN OFF shows on the commercial appliance

Before you book,
in this order.

Each step comes from Pitco's own guidance for DRAINING TURN OFF on its commercial appliances. Follow it to the end: the last card says whether this is a visit.

01

Turn the control off and push the blue drain handle fully in on manual models.

02

Refill the tank to the oil level line if any oil has drained, then turn the control back on.

03

If the handle is closed and the message will not clear, or an automatic drain will not close, book a visit to adjust or replace the drain switch or valve.

Still there?

It usually turns into dish machine repair. Book with the code and the model number.

What not to do

DRAINING TURN OFF is the fryer protecting an empty tank, not a heating failure. A drain that is closed but still shows DRAINING is a switch problem rather than a stuck valve.

What you may
notice with it.

The commercial appliance problems DRAINING TURN OFF tends to arrive with. Answer these at the commercial appliance before anyone is booked.

All problems

Where DRAINING TURN OFF usually leads

Dish machine repair.

Dish machine tank heater or booster element, thermostat, fill valve, float switch, drain valve, wash pump seal or motor, conveyor drive · moderate.

In Pitco's own words

If display reads “DRAINING” “TURN OFF”, verify that the drain valve is closed, check the proximity switch
Pitco Solstice and Solstice Supreme SG/SSH series gas fryer service manual (L22-345 R1) Pitco SSHLV14 and SSHLV184 series installation and operation manual (L20-407 rev.5) Pitco Solstice and Solstice Supreme installation and operation manual (L20-378 rev.4)

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Pitco computer controls show DRAINING and TURN OFF; the Digital Solid State Control shows drn tUrn oFF; SSHLV14 and SSHLV184 scroll DRN TRN OFF; SELV electric fryers show Draining Turn Off.

Pitco DRAINING TURN OFF commercial appliance repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A restaurant team working a busy commercial kitchen line.
For the heart of your home.

Questions
about DRAINING TURN OFF.

Can I clear DRAINING TURN OFF myself?
Turn the control off and push the blue drain handle fully in on manual models. If it comes back, it needs a visit.
Why does my Pitco say DRAINING when the drain is closed?
Pitco's troubleshooting chart gives two causes: the blue handle not pushed all the way in, or a drain switch that is out of adjustment or defective.
Can I bypass the drain interlock on a Pitco?
No. It exists so the burners or elements never fire into a draining tank. A switch that fails needs replacing, not bypassing.
What if the automatic drain on my Pitco will not close?
Pitco says an obstruction in the drain line can hold it open. Let the fryer cool fully before anyone clears it; a valve that still stays open needs a technician.

Back to your everyday

Still showing DRAINING TURN OFF?

A booking with a code goes further when it has the code as shown, the model and serial from the data plate, and a word on whether the unit still holds temperature, heats, rinses or spins. With those three, the office can match the likely part to your unit the same day.

(844) 571-4566 Schedule a repair