A gray electrical disconnect box on a tiled commercial kitchen wall beside a stainless convection oven, the oven's heavy power cord running up to it, the disconnect handle set to off, nobody near it.

Traulsen ELE LOS: the cabinet lost power at some point

On R & A Series cabinets and on TE, TU and TS units, the control remembers a power interruption and flashes ELE LOS in turn with the cabinet temperature.

(844) 571-4566

Mon–Sat, 8am–8pm

  • Controls and power
  • Commercial controls and board repair
  • Source: Traulsen

Book a visit

Three short steps, about a minute.

or call (844) 571-4566

What ELE LOS
actually means.

On R & A Series cabinets and on TE, TU and TS units, the control remembers a power interruption and flashes ELE LOS in turn with the cabinet temperature. Traulsen also shows it on first start-up, when the unit has just been plugged in. The unit runs normally while the message shows.

Traulsen commercial appliance display · also shown as ELE, LOS

What to do when ELE LOS shows on the commercial appliance

Before you book,
in this order.

Each step comes from Traulsen's own guidance for ELE LOS on its commercial appliances. Follow it to the end: the last card says whether this is a visit.

01

Read the cabinet temperature on the display and probe the food to see how warm it got while the power was off.

02

Log the reading and, if food was above 41°F, follow your health code on discard.

03

Press the alarm key once to clear the message.

04

If ELE LOS returns with no known outage, book a visit to check the cord, plug and outlet.

Still there?

It usually turns into commercial controls and board repair. Book with the code and the model number.

What not to do

ELE LOS does not mean the control or compressor has failed; it is a record of an event. A message that returns every day with no outage points to a loose plug, a tripping breaker or a worn cord.

Where ELE LOS usually leads

Commercial controls and board repair.

Controller, touch panel, probe or sensor, relay, contactor, power supply, door switch or interlock, tested before anything is changed · moderate.

In Traulsen's own words

ELE LOS: Indicates that the power supply has been interrupted.
Traulsen All Series quick reference guide, owner's manual TR35924 rev. C (2015), linked from traulsen.com owner's manuals Traulsen All Series quick reference guide, owner's manual TR35924 rev. C (2015), linked from traulsen.com owner's manuals

Every code on this site is taken from the manufacturer's documentation, never from a forum or a parts listing. Printed by the control on Traulsen R & A Series and TE/TU/TS Series units, per the quick reference guide TR35924 (rev. C, 2015).

Traulsen ELE LOS commercial appliance repair,
where we come out.

The same visit in every metro below: the code, the model number, and a diagnosis before any part is ordered.

All service areas
A restaurant team working a busy commercial kitchen line.
For the heart of your home.

Questions
about ELE LOS.

Can I clear ELE LOS myself?
Read the cabinet temperature on the display and probe the food to see how warm it got while the power was off. If it comes back, it needs a visit.
Why did my new Traulsen show ELE LOS the first day?
Traulsen notes the control flashes ELE LOS after power is first supplied. Clear it with the alarm key and it should not come back.
Does ELE LOS on a Traulsen mean the food is unsafe?
Not by itself. It tells you power was lost, so check the food and the log to see how long the cabinet was warm.
How do I clear ELE LOS on a Traulsen?
Press the alarm key below the display once. If the message returns without a blackout, the power supply to the unit needs checking.

Back to your everyday

Still showing ELE LOS?

A booking with a code goes further when it has the code as shown, the model and serial from the data plate, and a word on whether the unit still holds temperature, heats, rinses or spins. With those three, the office can match the likely part to your unit the same day.

(844) 571-4566 Schedule a repair